Low installation cost, beautiful aluminum alloy pipeline

It is made of high quality aluminum alloy, coated with epoxy resin, and the inside of the pipe is specially treated to avoid oxidation. The inner surface is smooth and never corrode. FST air piping system delivers high quality air from the gas production end to the use end anytime and anywhere to ensure the continuity and stability of downstream equipment and production process. At the same time, anti-corrosion, no leakage characteristics, long time operation, ensure zero leakage in the process of air transmission, effective prevention and control of energy loss.

The smooth inner surface, full diameter and internal diversion of dalian aluminum alloy pipeline are optimized to reduce air flow resistance, achieve low pressure drop of pipeline and excellent flow rate. The operation cost caused by pressure drop is as much as 5% (the energy consumption of the installed power is reduced by 7% per pressure drop). High performance o-type sealing ring is adopted to ensure excellent sealing and no leakage.

The price of aluminum alloy pipe and joint is higher than that of galvanized pipe. Aluminum alloy steel tube can not be used as a water pipe, because the aluminum tube is less rigid than galvanized pipe, but very flexible. The inner surface of galvanized steel tube is bright and clean. Small pressure loss of compressed air, energy saving. Galvanized steel pipe is beautiful and simple. Aluminum alloy is easy to install and quick to plug. Installation costs are low. Aluminum alloy is easy to disassemble, move and modify.

Pressure drop problems in conventional pipelines; Even for newly installed carbon steel pipes, the inner wall is rough (internal roughness is 1.9 microns) and the roughness is increased year by year due to corrosion, which directly results in flow reduction and pressure drop. The latter hazard is caused by leakage from conventional piping, whether it is from wire jacketed or welded carbon steel piping,

In the silk mouth and welding scar part, corrosion always starts first, and in serious cases, it is directly broken through on the right of the figure, resulting in leakage. The calculation table of leakage and energy consumption: take the common small hole leakage of 2mm as an example, the electricity charge is 1 yuan/KWH; The annual power consumption of each leaking hole =6554KWH×1 yuan/KWH =6554 yuan. With the increase of time, the corrosion of traditional pipelines will increase, and more and more leakage points will appear in the pipe network.