How to clean the compressed air line correctly

Compressed air pipeline how to reduce energy consumption, is a common concern. The compressed air pipeline includes air compressor, post-treatment equipment, air supply pipe network and ventilation and cooling facilities. In the design and planning of compressed air pipeline system, according to the actual use of requirements and characteristics of comprehensive consideration, reasonable selection and allocation of air compressor, compressed air pipeline optimization to reduce transmission resistance, for energy saving and consumption to lay a solid foundation.

The valve on the main road should be removed and cleaned with solvent. Some car companies use butyl ether to clean the valve. In order not to allow the valve to be polluted during purging, do not install temporarily after cleaning, choose a clean position and keep it properly. Main pipe diameter more sundries, particle diameter is also larger, the position of discharge sundries in the main valve installation position. According to the direction of compressed air, remove the valve behind the general valve of painting workshop, then open the general valve of compressed air, and install the cleaned valve after blowing the compressed air pipeline.

Air compressor operation management, air compressor intake air compressor with air as raw materials, to ensure the supply of raw materials is necessary. There are two kinds of air compressor intake: one is indoor intake, the other is outdoor concentrated intake. The outdoor centralized air intake has the following characteristics: first, it is convenient for centralized pre-filtration treatment; Second, it is not affected by indoor temperature and oil and gas. Third, reduce the indoor air flow and flow speed, is conducive to maintain indoor environmental health; Fourth, the initial investment is large, compressed air pipeline resistance loss. In comparison, outdoor air intake is better than indoor air intake.

Compressed air is one of the most widely used power sources in industry. It has many advantages such as safety, good regulating performance, convenient transportation, etc. It is widely used in the fields of modernization, automation and other industries. To get good quality compressed air needs energy consumption, but most compressed air pipeline system, due to various reasons, the operating efficiency is very low, serious energy waste. This requires us to have the concept and measures of energy saving when designing compressed air piping system and selecting equipment, so as to fundamentally reduce energy consumption, which not only conforms to the requirements of energy saving and emission reduction in China, but also conforms to the development trend of low-carbon economy worldwide.

Such as according to the structure and principle of different types of compressor, appropriate transformation, heat recovery, combined with the actual situation of the factory for use, then waste can be turned into treasure, the original discharged into the environment of heat collection and utilization, can reduce fuel consumption.